Rear Seal

This topic has 0 replies, 1 voice, and was last updated 1 month, 3 weeks ago by Precise Automotive Ltd..

Viewing 1 post (of 1 total)

Author

Posts
September 17, 2025 at 12:46 pm #240060
Precise Automotive Ltd.
Participant
Long Shot!! We are looking for a two piece rear seal for a small block Ford that is a new old stock. Some in gasket sets used to have the Ford part number on them. The new replacements from Felpro seem to stand off out of the seal groove an excessive amount. The rear seal did not leak on the dyno but did shortly after install in the vehicle. Worst case we will remove, dis-assemble, and machine for a one piece. A lot of work! Perhaps you have a dusty old JV730R or a BS30136.

Jim #94
Author

Posts

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

Welcome to E.R.I. Members Forum -The forum is intended for our members to share information with each other. To post a message, click on the name of the forum. Four forums have been set up, Buy/Sell, General Discussion, Members Able to Supply Products and Tech Help. When you are in the forum, and wish to post a message, click on the "New Topic" button. To view any posted message, click on the message. When you reply to a posted message, your message will be added to the topic.