5 cylinder 82.5 mm bore. Customer supplied .5mm O/S pistons. Cut .010″ first hole. Went down about an inch. There’s no sleeve left. Any suggestions?
G
063
9058-270-4561
Author
Posts
Viewing 1 post (of 1 total)
You must be logged in to reply to this topic.
Welcome to E.R.I. Members Forum -The forum is intended for our members to share information with each other. To post a message, click on the name of the forum. Four forums have been set up, Buy/Sell, General Discussion, Members Able to Supply Products and Tech Help. When you are in the forum, and wish to post a message, click on the "New Topic" button. To view any posted message, click on the message. When you reply to a posted message, your message will be added to the topic.
.
